上海快三彩票app下载_上海快3官网

上海快三彩票app下载

National Service Hotline:
eighteen billion twenty-one million eight hundred and eight thousand eight hundred and eighty-three
contact us contact us
eighteen billion twenty-one million eight hundred and eight thousand eight hundred and eighty-three

Contact person: Mr. Ling

Fax No.: 0515-88600022

1808021888

JSD: email_ yc0515@126.com

Address: No.9, Zefu South Road, Yandu District, Yancheng, Jiangsu Province

Industry trends

Air heater -- JinShengDa professional manufacture

Published on: August 2016

Air heater

The electric heater is composed of junction box, electric heating pipe and temperature controller. The junction box includes two parts: junction box and electric heating pipe connecting plate. It is composed of junction box and electric heating pipe, and its structural design parameters conform to the relevant provisions of electrical equipment.

instructions:

1) a set of automatic temperature control equipment must be set at the outlet of flowing gas pipeline to form protection with a set of automatic temperature control equipment equipped in the electric heater.

2) the working voltage shall not exceed 1.0 times of its rated voltage, and the inner and outer shells shall be effectively grounded.

3) the air source must be connected before starting the work, and it is not allowed to dry burn the gas.

4) regularly check the surface of the electric heating tube. If there is carbon deposition, it must be used after removing all the carbon. At the same time, check the cylinder body, corrosion degree, whether the container and electric heating tube need to be replaced every 1 year.

5) carefully check whether the electrical and instrument control system and lines matched with the electric heater are in good condition, and fasten all bolts to confirm whether they can be put into use.

6) the insulation resistance of the electric heating tube should be measured before each start-up. When it is lower than 2m Ω, the electric heating tube should be pulled out and put in the oven not higher than 300 ℃ for drying before use.

If you need to customize, please provide voltage / power, operating temperature, wiring mode, cylinder diameter (DN), cylinder length and material, etc!

Technical consultation hotline: 180218088883




Copyrights (c) 2016 All Rights Reservered.

Copyright: Yancheng JinShengDa electric heating equipment factory Record No Su ICP Bei 16009560 technical support: Jiangsu Baituo Information Technology Co., Ltd